What is the CLI command to configure LACP on Ruijie Switch?
You can use these CLI commands to configure static link aggregation on Ruijie Switch:Ruijie>enable
Ruijie#config
Ruijie(config)#interface range gigabitEthernet 0/1-3
Ruijie(config-if-range)#port-group 1 mode active
Ruijie(config-if-range)#exit
Ruijie(config)#interface aggregateport 1
Ruijie(config-if-AggregatePort 1)#switchport mode trunk
Ruijie(config-if-AggregatePort 1)#end
Ruijie#wr
Pages:
[1]