|
How to configure the multicast-to-unicast function |
|
The multicast-to-unicast function is used tomake multicast video smoother. Configuration reference: (1) Enable the multicast routing protocol ina Layer-3 device in the same broadcast domain. (2) In fit (ap-config) mode, run the followingcommand: Ruijie(config)# ip igmpsnooping ----->Enables igmp snooping for all VLANS. Toenable this function for certain VLANs, run the ip igmp snooping vlan 1 command. Ruijie(config)#ap-config xxx Ruijie(config-ap)# igmp snoopingmcast-to-unicast enable Ruijie(config-ap)# igmp snoopingmcast-to-unicast group-range ip-addrip-addr ----->(Optional) Defines themulticast-to-unicast scope. In fat mode, run the following command: Ruijie(config)#ip igmpsnooping ----->Enables igmp snooping forall VLANS. To enable this function for certain VLANs, run the ip igmp snooping vlan 1 command. Ruijie(config)#ip igmp snoopingmcast-to-unicast enable |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 4
