How does the traffic Detection of Web Authentication work

How does the traffic Detection of Web Authentication work

Traffic detection is enabled in Webauthentication mode by default. When a user having passing Web authenticationhas no traffic passing through the device within the specified no trafficperiod, the device deems that the user has gone offline and kicks the user out.

AP 11.x supports global notraffic detection and wlansec no traffic detection. The wlansec no trafficdetection has a higher priority. When wlansec no traffic detection takeseffect, global no traffic detection does not take effect.

In global no traffic detection mode, if theuser has no traffic in eight hours, the user is kicked off by default. Thecommand is as follows:

Ruijie(config)# offline-detectinterval   xx  threshold  yy

xx indicates the time, which is an integerranging from 1 to 65535, and the unit is minute. The default value is 8 hours.

yy indicates the traffic size, which is aninteger ranging from 0 to 4,294,967,294, and the unit is byte. The defaultvalue is 0.

In wlansec no traffic detection mode, if theuser has no traffic in 15 minutes, the user is kicked off by default. Thecommand is as follows:

The wlansec no traffic detection has a higher priority. Therefore, users having no traffic in 15 minutes are kicked out in15 minutes by default.

     WS(config)#wlansec 7    -------It is the actual authenticatedwlansec serial number.

         WS(config-wlansec)#web-auth offline-detect ?

             flow      Configure no flow threshold

              interval  Configure no flow interval