Ruijie Community

Title: How to configure the multicast-to-unicast function [Print this page]

Author: admin Time: 2018-4-12 00:53
Title: How to configure the multicast-to-unicast function
How to configure the multicast-to-unicast function

Author: admin Time: 2018-4-12 00:54

The multicast-to-unicast function is used tomake multicast video smoother.

Configuration reference:

(1) Enable the multicast routing protocol ina Layer-3 device in the same broadcast domain.

(2)

In fit (ap-config) mode, run the followingcommand:

Ruijie(config)# ip igmpsnooping ----->Enables igmp snooping for all VLANS. Toenable this function for certain VLANs, run the ip igmp snooping vlan 1 command.

Ruijie(config)#ap-config xxx

Ruijie(config-ap)# igmp snoopingmcast-to-unicast enable

Ruijie(config-ap)# igmp snoopingmcast-to-unicast group-range ip-addrip-addr ----->(Optional) Defines themulticast-to-unicast scope.

In fat mode, run the following command:

Ruijie(config)#ip igmpsnooping ----->Enables igmp snooping forall VLANS. To enable this function for certain VLANs, run the ip igmp snooping vlan 1 command.

Ruijie(config)#ip igmp snoopingmcast-to-unicast enable

Welcome to Ruijie Community (https://community.ruijienetworks.com/)