Access Point Config Status Failed
|
Edited by Jayso Roque at 2024-4-25 14:38 Hi Ruijie, Just to inquire, our wifi access point was upgraded to latest firmware version. However, we encounter Config Status Failed after the successful upgrade. See screen capture below. How do we fix it? Please advice. |
|
Dear sir You can try the following two steps to fix it 1.try manually deliver 'Manually Deliver'  2.If your device is unable to sync with the SSID synchronization item, you can try to save the SSID configuration again.   |
GTAC-Joy replied at 2024-4-25 14:36 Hi, Thank you very much for the assistance. It works. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
