- Can two RAPs that support mesh connect by the wireless repeater? (0Replies)
- When the RAP SON do mesh, must the RAP be the master? (0Replies)
- What will RAP do if the uplink device fails during the process of mesh? (0Replies)
- Can RAP connect the devices of other brands by wireless repeater? (0Replies)
- Can RAP do mesh with the devices of other brands? (0Replies)
- Will the Reyee AP mesh affect the roaming experience of terminals? In a mesh SON, why does the rate will decrease after the STA roaming? (0Replies)
- Does the Reyee AP mesh can designate the next hop? (0Replies)
- If the EG works as the AC mode, can it do the SON establishment? And can it support mesh? (0Replies)
- If the SON function is disabled, can the RAP in the network still support mesh? (0Replies)
- If a Root AP establishes the mesh with 4 downlink Reyee APs, How to allocate the bandwidth of these 4 downlink APs? (0Replies)
- Why is a maximum of three hops recommended for establishing the mesh SON? (0Replies)
- What is the recommended number of the mesh accesses? (0Replies)
- What factors does the Master AP consider when doing the link optimization? (0Replies)
- After multiple APs are detected by searching and pairing on the SON, how do I check how these APs are connected? (0Replies)
- If the AP is disconnected with the cable, how long does it take for the AP mesh the SON again? (0Replies)
- In the SON, what's the maximum capacity when Reyee devices are wired or wireless connected? (0Replies)
- Why does the wireless bandwidth of the next hop AP decrease by 50% with each additional hop? (0Replies)
- How to select the Root AP of the mesh AP? Is possible the selected Root AP not the optimal one? (0Replies)
- Is it necessary to associate a specific AP when establishing Mesh? (0Replies)
- Can the AP only amplify the signal but not forward the wireless data when it works as the wireless repeater mode? (0Replies)