How to access enterprise switch web page?
Step1: Configure HTTP/HTTPS serviceenable service web-server http
enable service web-server https
Step2: Configure a management ip address
The SVI and router port address can be used as the management address of the layer 3 switch.
Configuration Method 1:
Ruijie>enable
Ruijie#configure terminal
Ruijie(config)#interface vlan 10
Ruijie(config-if-VLAN 10)#ip address 192.168.1.1 255.255.255.0
Ruijie(config-if-VLAN 10)#end
Ruijie#writeNote: To configure the address for VLANs other than VLAN 1 in interface configuration mode, create the corresponding VLAN first; otherwise, a failure prompt is displayed.
Configuration Method 2:
Ruijie>enable
Ruijie#configure terminal
Ruijie(config)#int GigabitEthernet 1/1
Ruijie(config-if-GigabitEthernet 1/1)#no switchport//configure the port as layer 3 port before configuring ip address
Ruijie(config-if-GigabitEthernet 1/1)#ip add 192.168.16.1 255.255.255.0
Ruijie(config-if-GigabitEthernet 1/1)#end
Ruijie#write //save configuration after checking
You must use the LINE console to configure the management address. You can then use this address to manage your devices.
Step3: Then set the PC to the same network segment as management address you set, you can access the web interface of the switch
Edited by candy candy at 2022-10-6 12:48
otis jame replied at 2022-6-29 11:02
There are two ways of accessing the Enterprise Switch web page: If you have administrator access to...Create a management IP address so that you may connect to the switch's web interface. After creating a web user, access the web system. It's exactly what my basketball stars friends and I did, isn't it great
Make sure that the IP addresses of the PC and the management interface are in the same network segment.
Pages:
[1]