How to configure access port on Ruijie switch?
The following example shows how to configure interface F0/1 as the access port and assign interface F0/1 to VLAN 100Ruijie>en
Ruijie#conf t
Ruijie(config)#interface fastEthernet 0/1
Ruijie(config-if)#switchport mode access
Ruijie(config-if)#switchport access vlan 100
Ruijie(config-if)#end
Ruijie#wr
Make sure to adapt the configuration to your specific interface and VLAN requirements. Additionally, it's always a good practice to save the configuration to ensure that your changes are persistent after a reboot.
Pages:
[1]