Can't establish mesh network
Hi community,I got 2 RAP-6202 and one eg105g(v2), and i can not set up mesh. All devices are with actual firmware, i got one ap and the router configured, and one ap in default state (can see @ruijie-sXXXX ssid).After scanning and adding i receive a message that i need to put APs closer to each other. In fact, they are on a table side by side.data/attachment/forum/202306/24/020403pm4ams4zf2mgs4h1.jpg
Please help to set up mesh
Hi
May I know what are the firmware version for the devices?
What is the network topology you connected now?
May you try to reset this RAP6202G?
Regards
GTAC-Harvey replied at 2023-6-25 12:44
Hi
May I know what are the firmware version for the devices?
Hi Harvey.
Firmware is 1.219.1625 on both APs, 1.219.1722 on EG105G-V2
Topology is very simple, and both APs are on the same table, side by side to each other.
data/attachment/forum/202306/26/184817ab0f5i60c3j753bu.jpg
Pages:
[1]