Forum › Switch › How to configure LACP on Ruijie Switch via CLI commands?

linyonghang1@ru Publish time 2023-8-15 10:40:17

How to configure LACP on Ruijie Switch via CLI commands?

You can type these CLI commands to configure LACP on Ruijie Switch:

SW1>enable

SW1#configure

SW1(config)#interface range gigabitEthernet 0/1-3

SW1(config-if-range)#port-group 1 mode active//Configure port 1-3 as the same LACP group

SW1(config-if-range)#end

SW1#write

View full version: How to configure LACP on Ruijie Switch via CLI commands?