Ruijie Community

Title: What is the function of theradius-server attribute nas-port-id format qinq command? [Print this page]

Author: admin Time: 2017-5-3 17:44
Title: What is the function of theradius-server attribute nas-port-id format qinq command?
What is the function of theradius-server attribute nas-port-id format qinq command?

Author: admin Time: 2017-5-3 17:44

The radius-server attribute nas-port-id format qinq command has the following functions:

After this command is configured, the authentication and accounting packets sent by the N18K device and the SAM server carry two-layer VIDs.
Upon searching the two-layer VID, the SAM server displays the star topology and locates the user port.

This command should be disabled in the following situations:

The SAM version is earlier than V3.98, that is, the QinQ is not supported. This command cannot be enabled on the N18K device because the authentication packets that contain two-layer tags may not be identified by the SAM server, resulting in an authentication failure. The following command should be used:

Welcome to Ruijie Community (https://community.ruijienetworks.com/)