Ruijie Community

Title: Change mode FIT/FAT/MACC model RG-AP710 [Print this page]

Author: danhkun@gmail.c Time: 2025-3-26 17:15
Title: Change mode FIT/FAT/MACC model RG-AP710
I have model RG-AP710 but its led status is organe. (may be mode FIT/FAT) so this offline in my cloud. I want change mode but i don't know how change mode.

Author: liuxiyang@ruiji Time: 2025-3-26 17:20
Hi sir,
Please refer to these commands

Ruijie>show ap-mode
Current mode: fit (fit is f[strong]it [/strong]mode; fat is [strong]fat [/strong]mode,macc is macc mode
)
Ruijie #ap-mode fat (switch to fat mode)
Ruijie #ap-mode fit (switch to fit mode)
Ruijie #ap-mode macc (switch to macc mode)

note：after you switch AP's work mode, the AP will reboot.

Best regards,
Steve

Author: danhkun@gmail.c Time: 2025-3-27 11:42

GTAC-Steve replied at 2025-3-26 17:20
Hi sir,
Please refer to these commands

Do you have detailed instructions on how to proceed? Because i not know do thats.

Author: liuxiyang@ruiji Time: 2025-3-27 11:51

dang Danh replied at 2025-3-27 11:42
Do you have detailed instructions on how to proceed? Because i not know do thats.

Hi sir,

You can log into the AP via console cable, then execute these commands:https://community.ruijienetworks.com/forum.php?mod=viewthread&tid=2600&extra=page%3D1

Best regards,
Steve

Author: danhkun@gmail.c Time: 2025-3-28 10:52

GTAC-Steve replied at 2025-3-27 11:51
Hi sir,

You can log into the AP via console cable, then execute these commands:https://community. ...

I followed the instructions, but when I connected the console cable and restarted the AP, using Putty (Press Ctrl+C
) to log into the boot, it showed this error.

Author: liuxiyang@ruiji Time: 2025-3-28 10:57

dang Danh replied at 2025-3-28 10:52
I followed the instructions, but when I connected the console cable and restarted the AP, using Pu ...

Hi sir,

Change AP's work mode not need log into boot interface.
If you want recover your AP's firmware, you can follow up this guide:https://community.ruijienetworks.com/forum.php?mod=viewthread&tid=3092&extra=page%3D1

Best regards,

Steve

Author: danhkun@gmail.c Time: 2025-3-28 12:07

GTAC-Steve replied at 2025-3-28 10:57
dang Danh replied at 2025-3-28 10:52
I followed the instructions, but when I connected the console c ...

So i don't press Ctrl+C into boot, but i see this notification . Where file "main_ap720-s.bin" and "rgos.bin"?. Maybe you connect my computer by Ultraview or Anydesk support me now, because i'm not IT profesional,i'm student ?
ID Anydesk :

Welcome to Ruijie Community (https://community.ruijienetworks.com/)