Ruijie Community

Title: Can I use the debug ip packet command to display the traffic that passes an RSR series router? [Print this page]

Author: admin Time: 2017-5-4 11:30
Title: Can I use the debug ip packet command to display the traffic that passes an RSR series router?
Can I use the debug ip packet command to display the traffic that passes an RSR series router?

Author: admin Time: 2017-5-4 11:31

No. The debug ip packet command is only used to display the traffic initiated by or destined for the specified router.

To display the traffic that passes the router, run the showip fpm flow | include [IP address] command with the corresponding IP address specified.

Welcome to Ruijie Community (https://community.ruijienetworks.com/)