Title: How to Setup WAN Load Balance on RG-EG [Print this page] Author: chenlin5@ruijie Time: 2021-4-22 15:27 Title: How to Setup WAN Load Balance on RG-EG [Video]How to Setup WAN Load Balance on RG-EG Author: admin Time: 2021-6-28 16:56 WAN Load Balance
The load balancing function distributes the data to multiple WAN interfaces to avoid the traffic congestion and provide redundancy. 1.Network Topology 2.Configuration Key Points
1. Configure IP address of the WAN ports and default routes.
2. Enable the load balancing policy.
3. Customize interface weight to ensure that traffic goes through the different egress according to weight. 3.Configuraiton Steps
Step 1: Configure WAN 0
Step 2: Change the LAN1 port to WAN port
Step 3: Configure WAN 1
Step 4: Enable Load Balance Step 5: Configure the interface weight 4.Configuration Verfication Advice to add the following configuration to convert to reachable link when one of link can't be reached
IP address： The IP need to be reached
Next Hop IP: The gateway IP of your WAN port IP
Welcome to Ruijie Community (https://community.ruijienetworks.com/)
Step 5: Configure the interface weight
