Ruijie Community

Title: Can the debug ip packet Command Be Executed to Display Traffic That Passes Through an RSR Router? [Print this page]

Author: admin Time: 2017-5-4 11:48
Title: Can the debug ip packet Command Be Executed to Display Traffic That Passes Through an RSR Router?
Can the debug ip packet Command Be Executed to Display Traffic That Passes Through an RSR Router?

Author: admin Time: 2017-5-4 11:48

No. The debug ip packet command is only used to display the traffic initiated by or the traffic destined for a router.

To display traffic that passes through a router, run the show ip fpm flow |include [IP address] command with the IP address specified.

Welcome to Ruijie Community (https://community.ruijienetworks.com/)