Ruijie Community

Title: Help with setting up M-Lag [Print this page]

Author: eromanov@rubyte Time: 2021-6-7 18:43
Title: Help with setting up M-Lag
Edited by eromanov@rubytech.ru at 2021-6-8 15:53

There is an RG-S6510-32CQ. How to configure M-Lag 40Gb on it?

Author: eromanov@rubyte Time: 2021-6-9 19:16
I have enabled the protocol spanning-tree v-stp enable and the information indicates that Mlag is disabled.
R2#sh spa v information

V-STP status                : enable
Local bridge mac          : c0b8.e674.34d0
Selected bridge mac       : 0000.0000.0000
Peerlink Port             : Virtual-port
Calculate Virtrual Index    : 4095
Mlag Remote device connected : N

MST 0 Root Port       : None

Two switches are connected by 40G and 1 aggregated port is made.

R2#sh aggregatePort 1 summary
AggregatePort MaxPorts SwitchPort Mode Load balance                Ports
------------- -------- ---------- ------ ---------------------------- -----------------------------------
Ag1          16    Enabled TRUNK  src-dst-mac                Hu0/1 ,Hu0/2

R2#sh vrrp brief
Interface          Grp  Pri timer Own  Pre State Master addr                            Group addr
VLAN 10             1 100 3.60 - P    Backup  10.0.10.11                               10.0.10.1
VLAN 20             1 120 3.53 - P    Master  10.0.20.12                               10.0.20.1
VLAN 30             2 100 3.60 - P    Backup  192.168.0.11                            192.168.0.10

R1#sh vrrp brief
Interface          Grp  Pri timer Own  Pre State Master addr                            Group addr
VLAN 10             1 120 3.53 - P    Master  10.0.10.11                               10.0.10.1
VLAN 20             1 100 3.60 - P    Backup  10.0.20.12                               10.0.20.1
VLAN 30             2 100 3.60 - P    Master  192.168.0.11                            192.168.0.10

what is the problem? HELP ME!!!

Welcome to Ruijie Community (https://community.ruijienetworks.com/)