The configuration guide to turn off ap led in fixed time is shown as below:
I. Requirements
Client wants to turn off AP LED in fixed time everyday automatically
II. Network Topology
III. Configuration Steps
Configuring turn off AP LED in fixed time
Fit AP
Configuring on AC
AC>enable
AC#configure terminal
AC(config)#schedule session 1
AC(config)#schedule session 1 time-range 1 period Wed time 13:30 to 20:20 ----->time range from 13:30 to 20:20 on Wednesday
AC(config)#clock timezone UTC +8 ---> set time zone, +8 hours offset
AC#clock set 11:33:00 8 6 2014 ---->set current time 11:33:00 6th Aug 2014
AC#show clock
AC#configure terminal
AC(config)#ap-config all
AC(config-ap)#quiet-mode session 1
AC(config-ap)#end
Recommend configure sntp, or the clock will return to the factory after reboot AP
AC(config)#sntp enable ----->enable sntp service
AC(config)#sntp server 192.168.2.1 ----->configure sntp server
AC#write
Fat AP
Configuring on Fat AP
FatAP>enable
FatAP#configure terminal
FatAP(config)#schedule session 1
FatAP(config)#schedule session 1 time-range 1 period Wed time 13:30 to 20:20
FatAP(config)#clock timezone UTC +8 ---> set time zone, +8 hours offset
FatAP#clock set 11:33:00 8 6 2014
FatAP#show clock
FatAP#configure terminal
FatAP(config)#quiet-mode session 1
FatAP(config-ap)#end
Recommend configure sntp, or the clock will return to the factory after reboot AP
FatAP(config)#sntp enable ----->enable sntp service
FatAP(config)#sntp server 192.168.2.1 ----->configure sntp server
FatAP#write
IV. Verification
1. ALL the LED, sys, wlan & wan LED on AP, are turned off
2. System prompts logs when quiet-mode takes effect:
[Wed, 13:55] Disable by schedule.
Welcome to Ruijie Community (https://community.ruijienetworks.com/) | Powered by Discuz! X3.2 |