Title: How to configure L2TP on Reyee Gateway [Print this page] Author: chenlin5@ruijie Time: 2021-8-27 21:30 Title: How to configure L2TP on Reyee Gateway How to configure L2TP on Reyee Gateway
Router To Router
Sample Topology
HQ Step 1:Choose VPN→L2TP and enable L2TP
Step 2：Configure L2TP setting and click save
Note:
1) The local address and the IP range of the address pool cannot conflict with the internal network address of the device itself Local address: the local virtual IP of the VPN tunnel, the PC can access the server through this address after dialing in Address pool IP range: the IP address pool assigned by the L2TP server to the branch
2) The PPP link maintenance interval is the default, which refers to the interval at which PPP link maintenance detection messages are sent after PPTP is connected.
Step 3：Choose VPN→VPN Clients and add users to allow branches to dial in with accounts
Note: Service type: select L2TP Network mode: select router to router Peer Subnet: fill in the internal network segment of the branch (be careful not to overlap with the internal network segment of the headquarters)
Branch Step 1:Choose VPN→L2TP and enable L2TP
Step 2：Configure L2TP setting and click save
Note: L2TP type: select L2TP client Username and password: fill in the username and password just added in the headquarters tunnel IP: This IP address is the address in the IP range of the address pool filled in by the headquarters. Selecting dynamic means randomly assigning the address of the address pool IP address. If selecting static, you can enter any address in the address pool IP by yourself without conflict. Server address: fill in the WAN port address of the headquarters (public network IP is required.This is a test, so it is a private network address) Peer Subnet: the internal network segment of the headquarters (do not overlap with the internal network segment of the branch) Work mode: The work mode here refers to whether the headquarters is allowed to access the branch intranet, if allowed, select [Routing], if not allowed, select [NAT]
Finally: Check the tunnel list
PC To Router
Sample Topology
HQ
Step 1:The same to Router to Router
Step 2:The same to Router to Router
Step 3：Choose VPN→VPN Clients and add users to allow PC to dial in with accounts
Note: Service Type: L2TP Network Mode: PC to Router
PC(Sample Windows 10) Step 1:Enter control panel→Network and Internet→Network and Sharing Center
Step 2:Configure VPN connection
Step 3:Change adapter setting
Step 4:Connect VPN
Welcome to Ruijie Community (https://community.ruijienetworks.com/)
