Ruijie Community

Title: How to configure policy route on EG? [Print this page]

Author: GTAC-Daisy Time: 2021-9-3 14:45
Title: How to configure policy route on EG?

I want VLAN 1 go through WAN 1, VLAN 2 go through WAN 2， how can I do it?

You can use the policy route to do it, for example

vlan 1 is 192.168.1.0 vlan 2 is 192.168.2.0.

WAN 1 is 10.100.10.1, gateway is 10.100.10.254

WAN 2 is 10.100.11.1，gateway is 10.100.11.254

Step 1 click route policy-base route， click add ACL

Step 2, Add two ACL 10 and 11，set ACE to permit 192.168.1.0 and 192.168.2.0

Step 3 Configure Policy route

Finished

Author: adriana.hs599@g Time: 2021-10-7 19:33
I have setup like this but my client seems to skip this rule and they keep go to WAN 1. My device EG-2100 v2p

Author: GTAC-Daisy Time: 2021-10-29 11:05

adriana.hs599@g replied at 2021-10-7 19:33
I have setup like this but my client seems to skip this rule and they keep go to WAN 1. My device EG ...

Dear sir,

The WAN 2 port are reachable right？
And please try to tracert on the client, to check where it can work

Welcome to Ruijie Community (https://community.ruijienetworks.com/)