Ruijie Community

Title: How to config WAN Load balance on Reyee EG? [Print this page]

Author: GTAC-Harvey Time: 2021-11-1 22:20
Title: How to config WAN Load balance on Reyee EG?

The load balancing function distributes the data to multiple WAN interfaces to avoid the traffic congestion and provide redundancy.

Network Topology

Configuration Steps

Step 1: Choose Router->Basics-> WAN

Step 2: Configure the WAN interface accordingly

Step 3: Choose ISP/Load Settings, and configure the load mode and interface weight

1.Balanced mode: The traffic will be spread across multiple links according to the weight of each WAN port. For example, if WAN and WAN1 weight are set to 3 and 2 respectively, 60% of the total traffic will be routed over WAN and 40% over WAN1.

2.Primary & secondary mode: All traffic is routed over the primary interface. Once the primary interface fails, traffic will be switched over to the secondary interface. If there are multiple primary and secondary interfaces, please configure their weight (See balanced mode).

Step 4: Save the configuration

Welcome to Ruijie Community (https://community.ruijienetworks.com/)