Ruijie Community

Title: How to configure jumbo frames on the Ruijie switch? [Print this page]

Author: GTAC-Sophia Time: 2021-11-12 14:58
Title: How to configure jumbo frames on the Ruijie switch?

The switch configuration jumbo frame is to configure the mtu to the maximum under the interface, namely

ruijie>enable

ruijie#conf

ruijie(config)#interface gigabitEthernet 0/1

ruijie(config-if-GigabitEthernet 0/1)#mtu 9216

Author: prasedenica89@g Time: 2022-8-31 16:01
To transfer traffic over switched networks, ensure that the MTU of the transmitted traffic does not exceed the MTU supported by the switch platforms
duck life

Author: GTAC-Sophia Time: 2022-9-2 15:26

prase denica replied at 2022-8-31 16:01
To transfer traffic over switched networks, ensure that the MTU of the transmitted traffic does not ...

It's a good addition!

Welcome to Ruijie Community (https://community.ruijienetworks.com/)