Ruijie Community

Title: How to configure NAT on AC？ [Print this page]

Author: GTAC-Daisy Time: 2021-12-16 14:24
Title: How to configure NAT on AC？
The NAT configuration guide is shown as below:

I. Configuration Steps

1. Configure DHCP pool for intranet users
Ruijie(config)#ip dhcp pool sta
Ruijie(dhcp-config)#network 192.168.1.0 255.255.255.0
Ruijie(dhcp-config)#dns-server 8.8.8.8
Ruijie(dhcp-config)#default-router 192.168.1.1

2. Configure ACL match intranet users' traffic
Ruijie(config)#ip access-list standard 1
Ruijie(config-std-nacl)#10 permit any

3. Configure IP address on the interface and set it as outside NAT interface
Ruijie(config)#interface GigabitEthernet 0/1
Ruijie(config-if-GigabitEthernet 0/1)# ip address 100.168.12.200 255.255.255.0
Ruijie(config-if-GigabitEthernet 0/1)#ip nat outside

4. Configure IP address on BVI interface 1 and set is as inside NAT interface
Ruijie(config)#interface BVI 1
Ruijie(config-if-BVI 1)#ip address 192.168.1.1 255.255.255.0
Ruijie(config-if-BVI 1)# ip nat inside

5. Configure address translation table
Ruijie(config)#ip nat inside source list 1 interface GigabitEthernet 0/1 overload

6. Configure default route pointing to gateway
Ruijie(config)#ip route 0.0.0.0 0.0.0.0 100.168.12.1

II. Verification

Intranet users are able to access the Internet.

Author: nullblp@gmail.c Time: 2021-12-23 23:45
Geat post! It is really informative. thanks a lot.
five nights at freddy's

Author: annajimmy3007@g Time: 2022-12-27 11:56
Thank you very much. Your post presented me with a wealth of information, allowing me to broaden my horizons

Five Nights at Freddy's

Welcome to Ruijie Community (https://community.ruijienetworks.com/)