Ruijie Community

Title: After policy-map Is Enabled on an Interface of an RSR Router, How to Check the Traffic Matched in the Default Queue? [Print this page]

Author: admin    Time: 2017-5-4 15:49
Title: After policy-map Is Enabled on an Interface of an RSR Router, How to Check the Traffic Matched in the Default Queue?
After policy-map Is Enabled on an Interface of an RSR Router, How to Check the Traffic Matched in the Default Queue?

Author: admin    Time: 2017-5-4 15:49
Configure a new class-map to match the remaining traffic. Check how much traffic is matched using the new class-map to check how much traffic is transmitted through the default queue. The command for checking how much traffic is transmitted through the new class-map queue is as follows:

Ruijie#show policy-map interface gigabitEthernet 0/0






Welcome to Ruijie Community (https://community.ruijienetworks.com/) Powered by Discuz! X3.2