Ruijie Community

Title: The Rate Limit Does Not Take Effect after ip rate-control is Configured. [Print this page]

Author: admin Time: 2017-5-4 15:53
Title: The Rate Limit Does Not Take Effect after ip rate-control is Configured.
The Rate Limit Does Not Take Effect after ip rate-control is Configured.

Author: admin Time: 2017-5-4 15:53

1. Check whether the source address of the test device is within the network segment defined in ACL.

2. Check whether the rate limit value is configured correctly. The unit of the rate in the command is KiloBytes/s.

Welcome to Ruijie Community (https://community.ruijienetworks.com/)