Title: What can I do if I fail to configure EST Bridge? [Print this page] Author: GTAC-Jenny Time: 2022-1-29 12:13 Title: What can I do if I fail to configure EST Bridge? a) Check the indicator of the EST device. If the wireless signal is too low to connect, you need to adjust the channel and the transmit power setting.
b) Check the working mode of the device. Ensure that one side is AP mode, and the other side is CPE mode.
c) Check the installation location of the EST device. Place the front panels of the two EST devices (AP end and CPE end) opposite each other to ensure that WIFI signals can be transmitted.
d) Check whether the radio configuration on both sides are consistent. They are consistent by default. If they are inconsistent, you can restore factory settings of the two EST devices to test again (press the reset button for more than 5s).
e) If the problem is still unsolvable, you may start a Live Chat with our Support Engineer for assistance: Ruijie Support.
Welcome to Ruijie Community (https://community.ruijienetworks.com/)