Ruijie Community

Title: The NAT Inside Interface Is Configured on the virtual-temp Interface on the LNS. The NAT Does Not Take Effect After the Client Dial-up Is Successful. [Print this page]

Author: admin Time: 2017-5-4 19:48
Title: The NAT Inside Interface Is Configured on the virtual-temp Interface on the LNS. The NAT Does Not Take Effect After the Client Dial-up Is Successful.
The NAT Inside Interface Is Configured on the virtual-temp Interface on the LNS. The NAT Does Not Take Effect After the Client Dial-up Is Successful.

Author: admin Time: 2017-5-4 19:48

[Operation Steps] The NAT inside interface is configured on the virtual-temp interface after the client dial-up is successful.

[Fault Cause] After the client dial-up is successful, one virtual-access interface is generated on the LNS. This interface is used for interworking with the client and its configuration is inherited from the configuration of the virtual-temp interface upon successful dial-up. The NAT inside interface is not configured during client dial-up. Therefore, the configuration of the virtual-access interface does not contain NAT inside interface. As a result, the preceding fault occurs.

[Solution] Make the client go offline and then perform dial-up again. Then, a virtual-access interface will be generated and the interface configuration will be loaded from the configuration of the virtual-temp interface.

Welcome to Ruijie Community (https://community.ruijienetworks.com/)