Ruijie Community

Title: How can I limit bandwith for vlan on reyee EG? [Print this page]

Author: Daisy Time: 2022-4-16 11:52
Title: How can I limit bandwith for vlan on reyee EG?

1. Click Router->Advanced->FlowControl->Enable, configure the WAN Bandwidth base on truth, such as ISP give you a cable with uplink 100Mbps and downlink 200Mbps, you can fill up 100and down 100 here, then click Save.

Notice: If you want totest the WAN rate, please disable smart flow control first.

2. After enable flowcontrol, you can see a new button CustomPolicy. Click it to allocate bandwidth to the specified VLAN IP address orrange. The priority is sorted as follows: Custom Policy > Smart Flow Control.

IP/IP Range: Set an IP address or IPaddress range.

Bandwidth Type: Shared indicates thatall IP addresses share the total bandwidth. Independent indicates that the rate limit is set per IP address.

Uplink Rate:

CIR: CIR indicates the committedinformation rate.

PIR: PIR indicates the peak informationrate.

Downlink Rate:

CIR: CIR indicates the committedinformation rate.

PIR: PIR indicates the peak informationrate.

Interface: Select a WAN port which thepolicy is applied to. If choose All WANPorts: The policy is applied to all WAN ports.

Status: Enable or disable a policy.

3. Do speed test,showing the guest which on default vlan only can reach under 2Mbps

Welcome to Ruijie Community (https://community.ruijienetworks.com/)