Ruijie>enableNote: To configure the address for VLANs other than VLAN 1 in interface configuration mode, create the corresponding VLAN first; otherwise, a failure prompt is displayed.
Ruijie#configure terminal
Ruijie(config)#interface vlan 10
Ruijie(config-if-VLAN 10)#ip address 192.168.1.1 255.255.255.0
Ruijie(config-if-VLAN 10)#end
Ruijie#write
Ruijie>enableYou must use the LINE console to configure the management address. You can then use this address to manage your devices.
Ruijie#configure terminal
Ruijie(config)#int GigabitEthernet 1/1
Ruijie(config-if-GigabitEthernet 1/1)#no switchport //configure the port as layer 3 port before configuring ip address
Ruijie(config-if-GigabitEthernet 1/1)#ip add 192.168.16.1 255.255.255.0
Ruijie(config-if-GigabitEthernet 1/1)#end
Ruijie#write //save configuration after checking
otis jame replied at 2022-6-29 11:02Create a management IP address so that you may connect to the switch's web interface. After creating a web user, access the web system. It's exactly what my basketball stars friends and I did, isn't it great
There are two ways of accessing the Enterprise Switch web page: If you have administrator access to ...
Welcome to Ruijie Community (https://community.ruijienetworks.com/) | Powered by Discuz! X3.2 |