Title: How to config static routing /default route on NBS switch? [Print this page] Author: panjingyi1@ruij Time: 2022-7-5 11:59 Title: How to config static routing /default route on NBS switch? Support model：
Configure Path:
a) Add a static routing
Click Add. In the displayed dialog box, you can set a Generic Static Route.
Specify the destination IP address and subnet mask, select an outbound interface from the Outbound Interface dropdown list, set a next hop address. If the outbound interface is enabled with PPPoE, the next hop address is not required.
Ping test：
b） Add default route
Click Add. In the displayed dialog box, you can set the Default Static Route.
Set both the destination IP address and the subnet mask to all 0s, then set a next hop address.
Ping test：
Welcome to Ruijie Community (https://community.ruijienetworks.com/)
