Title: how to configure aggregation port on AC? [Print this page] Author: Daisy Time: 2022-7-11 10:53 Title: how to configure aggregation port on AC? Static mode:
AC1>enable
AC1#configure terminal
AC1(config)#interface range gigabitEthernet 0/1-2 ------>configure a range of interfaces with the same command
AC1(config-if-range)#port-group 1 ------>put G0/1 and G0/2 in AP 1 in static mode
AC1(config-if-range)#exit
AC1(config)#interface aggregateport 1
AC1(config-if-AggregatePort 1)#switchport mode trunk ------>configure AP 1 as Trunk
AC1(config-if-AggregatePort 1)#exit
AC1(config)#aggregateport load-balance src-mac ------>modify load balance method to Src-MAC. By default, it is Src-Dst-MAC.
AC1(config)#exit
Dynamic mode:
AC1(config)#interface range gigabitEthernet 0/1-2
AC1(config-if-range)#port-group 1 mode active ------>put G0/1 and G0/2 in AP 1 in dynamic mode
AC1(config-if-range)#exit
AC1(config)#interface aggregateport 1
AC1(config-if-AggregatePort 1)#switchport mode trunk ------>configure AP 1 as Trunk
AC1(config-if-AggregatePort 1)#end
AC#wr
Welcome to Ruijie Community (https://community.ruijienetworks.com/)