| Fat or MACC mode: Login into AP, using the command as blew to configure the vlan of AP interface: AP>en AP#config ter AP(config)#vlan vlan-number AP(config)#interface gi 0/1.1 AP(config-if-GigabitEthernet 0/1.1)#encapsulation dot1Q vlan-number AP(config-if-GigabitEthernet 0/1.1)#ip dhcp snooping trust AP(config-if-GigabitEthernet 0/1.1)#exit AP(config)#interface gi 0/2 AP(config-if-GigabitEthernet 0/2)#encapsulation dot1Q vlan-number AP(config-if-GigabitEthernet 0/2)#end AP#wr Fit mode: WS6008>en WS6008#config ter WS6008(config)#ap-config ap-name WS6008(config-ap)# wired-vlan 10 port 1 auto-save //configure port 1 to vlan 10 WS6008(config-ap-config)#end WS6008#write Function support: Through the wired-vlan command can configure the vlan of wired network interface used, the configuration only can be effectively on the AP which have wired network interface, the model of AP only Fit AP products: They are AP110-W, AP120-W, AP120-S, AP130-W, AP130(L), AP130(W), MAP552,MAP552-W and AP3220-P. |
| Welcome to Ruijie Community (https://community.ruijienetworks.com/) | Powered by Discuz! X3.2 |