Title: How to configure static aggregate port on AC? [Print this page] Author: GTAC-Sophia Time: 2022-7-25 11:40 Title: How to configure static aggregate port on AC? Scenario: Configuration Steps:
● Add the GigabitEthernet 1/1 and GigabitEthernet 1/2 ports on Switch A to static AP port 3.
● Add the GigabitEthernet 2/1 and GigabitEthernet 2/2 ports on Switch B to static AP port 3.
SwitchA# configure terminal
SwitchA(config)# interface range GigabitEthernet 1/1-2
SwitchA(config-if-range)# port-group 3
SwitchB# configure terminal
SwitchB(config)# interface range GigabitEthernet 2/1-2
SwitchB(config-if-range)# port-group 3 Verification:
Run show aggregate port summary to check whether AP port 3 contains member ports GigabitEthernet 1/1 and GigabitEthernet 1/2
Welcome to Ruijie Community (https://community.ruijienetworks.com/)
