Ruijie Community

Title: How to Config Weight For Load Mode Primary & Secondary [Print this page]

Author: mr.hall.nok@gma Time: 2022-8-25 13:25
Title: How to Config Weight For Load Mode Primary & Secondary
If have 2 ISP ... Wan0 = 500 MB And Wan1 300 MB
Question 1 Router set config ( For Load Mode Primary & Secondary ) Wan 0 = Set as Primary Interface and Wan1 =Secondary Interface
So .. How to Config Wan0 Weight = xxxx ?

How to Config Wan1 Weight = xxxx ?

Question 2 Router set config ( For Load Balanced ) Wan 0 = Set as Primary Interface and Wan1 =Secondary Interface
So .. How to Config Wan0 Weight = xxxx ?

How to Config Wan1 Weight = xxxx ?

Author: zhangwei13 Time: 2022-8-25 15:06
Hi sir, sorry for not reply timely, you may refer to the below picture.

if Wan0 = 500 MB And Wan1 300 MB, then we suggest WAN0:WAN1 =5:13

Author: mr.hall.nok@gma Time: 2022-8-25 15:34

GTAC-Wayne replied at 2022-8-25 15:06
Hi sir, sorry for not reply timely, you may refer to the below picture.

Thank you so much
Balanced mode  and  Primary & Secoundary mode
All Mode  suggest WAN0:WAN1 = 5:13

If Wan0 =  5 MB And Wan1  3 MB    Suggest WAN0:WAN1 = 5:13  ?

Author: zhangwei13 Time: 2022-8-26 09:36

mr.hall replied at 2022-8-25 15:34
Thank you so much
Balanced mode and Primary & Secoundary mode
All Mode suggest WAN0:WAN1 = 5: ...

If Wan0 = 5 MB And Wan1 3 MB Suggest WAN0:WAN1 = 5:3. the weight ratio == the ratio of two WANs

Welcome to Ruijie Community (https://community.ruijienetworks.com/)