Title: How to check the uplink and downlink bandwidth of RSR Router? [Print this page] Author: GTAC-Sophia Time: 2022-11-13 17:07 Title: How to check the uplink and downlink bandwidth of RSR Router? Ruijie#sh int gi0/0 //int WAN port
Index(dec):3 (hex):3
GigabitEthernet 0/0 is UP, line protocol is UP
Hardware is RSR10-X GE CONTROLLER Gigabit Ethernet,address is 5869.6ce3.6c9f (bia 5869.6ce3.6c9f)
Description: 211.138.180.3
Interface address is: 111.11.11.*/24
ARP type: ARPA, ARP Timeout: 600 seconds
MTU 1500 bytes, BW 1000000 Kbit
Encapsulation protocol is Ethernet-II, loopback notset
Keepalive interval is 10 sec , set
Carrier delay is 2 sec
Rxload is 1/255, Txload is 1/255
Queueing strategy: FIFO
Output queue 0/40, 0 drops;
Input queue 0/75, 0 drops
Link Mode: 1000M/Full-Duplex, media-type istwisted-pair.
Output flowcontrol is off;Input flowcontrol is off.
5 minutes input rate25826
bits/sec, 36 packets/sec //download25kb, the default unit is b
5 minutes output rate 25118
bits/sec, 39 packets/sec //upload25kb, the default unit is b