Title: What are the functional limitations of the VAC deployment? [Print this page] Author: GTAC-Sophia Time: 2022-11-17 13:47 Title: What are the functional limitations of the VAC deployment? 1. VAC does not support IPV6, NAT (NAT is enabled on AC), GSN, RPCAP, RF ping, RRM, WIDS, STP, RSTP, MSTP, and MESH
2. VAC does not support built-in web authentication, first-generation web authentication
3. VAC does not support hot spare between VAC and VAC also does not support roaming between VAC and VAC
4. VAC does not support related control domain, co-frequency networking, wireless positioning, cloud AC management, AC forwarding mode and so on
5. AP load balancing does not support load balancing on the AC, it depends on the load balancing of the aggregation port connected to the switch
6. The AC/AP cross-NAT deployment scenario is affected. In this scenario, the source IP addresses of APs may be the same, and the APs with the same source IP address will be loaded to the same AC, resulting in poor load balancing effect.
7. Port mirroring is not supported. When port mirroring is enabled, packets are transmitted through the VSL, which may lead to VAC splitting.
8. VAC currently does not support centralized forwarding roaming across WLANs
9. VAC cannot be deployed in the 2 ACs which across NAT
Welcome to Ruijie Community (https://community.ruijienetworks.com/)