Ruijie Community

Title: EG105G-V2 _ Enable a WAN failover using LTE - [Print this page]

Author: Zunaid Time: 2023-1-29 23:18
Title: EG105G-V2 _ Enable a WAN failover using LTE -
Good day

Is it possible to use LTE as a wan failover, not load balance, But complete failover if there is no longer internet connection on WAN 0.

Can WAN 1 be used as the next internet connection? Using A LTE router into the Ruijie Router WAN1.

Author: GTAC-Micca Time: 2023-1-30 09:48
May I have your topology so that I can help you more efficiency？

Author: Zunaid Time: 2023-1-31 04:08

Micca replied at 2023-1-30 09:48
May I have your topology so that I can help you more efficiency？

WAN(isp) -> RG Gateway -> Ruijie AP.

Author: yujiamin@ruijie Time: 2023-1-31 11:59

Zunaid replied at 2023-1-31 04:08
WAN(isp) -> RG Gateway -> Ruijie AP.

Dear sir

You have two WAN ports on the eg, and want to set WAN0 as primary link and WAN1 as secondary link right?

Best regards
Jenny

Author: Zunaid Time: 2023-2-20 14:09

GTAC-Jenny replied at 2023-1-31 11:59
Dear sir

You have two WAN ports on the eg, and want to set WAN0 as primary link and WAN1 as secon ...

Hi Jenny

that is correct, WAN 0 - Fibre Connection. WAN 1 LTE connection.
Should fiber fail, it should jump over to LTE

I have setup the dual WAN and but the failover still doesnt work.

Author: yujiamin@ruijie Time: 2023-2-20 18:33

Zunaid replied at 2023-2-20 14:09
Hi Jenny

that is correct, WAN 0 - Fibre Connection. WAN 1 LTE connection.

Dear sir

You can follow this guide to achieve this function:
https://community.ruijienetworks.com/forum.php?mod=viewthread&tid=4080&extra=page%3D1

Best regards

Jenny

Welcome to Ruijie Community (https://community.ruijienetworks.com/)