Ruijie Community

Title: After Interfaces of the N18000 Are Aggregated, Why Does the Speed Displayed After the show interface status Command Is Executed Keep Unchanged? [Print this page]

Author: admin Time: 2017-5-3 16:00
Title: After Interfaces of the N18000 Are Aggregated, Why Does the Speed Displayed After the show interface status Command Is Executed Keep Unchanged?
After Interfaces of the N18000 Are Aggregated, Why Does the Speed Displayed After the show interface status Command Is Executed Keep Unchanged?

Author: admin Time: 2017-5-3 16:00

The speed displayed after the show interface status command is executed is the speed of a member interface rather than the speed of the aggregate port. If the speeds of member interfaces that are statistically aggregated are different, the speed of the last member interface in the up state is displayed after this command is executed.

The details are as follows:

Ruijie(config)#int range g1/21 - 22

Ruijie(config-if-range)#port-group 1

Ruijie#show interface status | in up

InterfaceStatus Vlan Duplex Speed Type

GigabitEthernet 1/21up1Full1000Mcopper

GigabitEthernet 1/22up1Full1000Mcopper

AggregatePort 1 up1Full 1000M copper

To display the speed of AP Port 1, run the show interface aggregateport X command:

Ruijie#show interface aggregateport 1

Index(dec):97 (hex):61

AggregatePort 1 is UP , line protocol is UP

Hardware is AggregateLink AggregatePort, address is 1414.4b75.bc96 (bia 1414.4b75.bc96)

MTU 1500 bytes, BW 2000000 Kbit

Aggregate Port Informations:

Aggregate Number: 1

Name: "AggregatePort 1"

Members: (count=2)

GigabitEthernet 1/21Link Status: Up

GigabitEthernet 1/22Link Status: Up

Welcome to Ruijie Community (https://community.ruijienetworks.com/)