Title: RP-820-L V3 [Print this page] Author: dinko@sampro.rs Time: 2023-3-7 17:40 Title: RP-820-L V3 After hardware reset (factory defaults, holding reset button more than 5 seconds) Device is still in RED LED blinking mode
Before that first was blinking green, than steady green, than again green and got in to red blinking status since than. It s already 20 minutes in that condition and status is not changing..
Happened on 2 devices....
Device is just connected to PoE injector 48V , not connected to internet Author: GTAC-Patrick Time: 2023-3-7 19:36
After factory reset, ruijie AP will be in the Fit mode.
You can check the hardware guide about the LED status of AP820-L(V3) in Fit mode: https://www.ruijienetworks.com/resources/preview/77234?t=638138139210205078
Could you connect your PC to AP's LAN 1, set IP of your PC into 192.168.110.x/24, then login to the eweb of this AP via this default ip: 192.168.110.1? Check if the eweb of AP is available or not.
Welcome to Ruijie Community (https://community.ruijienetworks.com/)
