Ruijie Community

Title: When PBR Is Configured for a Device Using the RGOS 11.X Software Platform? [Print this page]

Author: admin Time: 2017-5-3 16:06
Title: When PBR Is Configured for a Device Using the RGOS 11.X Software Platform?

When PBR Is Configured for a Device Using the RGOS 11.X Software Platform, Can the Device Be Correlated to Monitor the Next-Hop Reachability Based on the PBR and Perform Operations Based on the Up/Down State of Interfaces?

Author: admin Time: 2017-5-3 16:09

Correlation with DLDP

PBR part:

Ruijie(config)#ip access-list standard network_1

Ruijie(config-std-nacl)# 10 permit 200.24.16.0 0.0.0.255

Ruijie(config)#ip access-list standard network_2

Ruijie(config-std-nacl)# 10 permit 200.24.17.0 0.0.0.255

Ruijie(config)#route-map PBR permit 10

Ruijie(config-route-map)# match ip address network_1

Ruijie(config-route-map)# set ip next-hop 200.24.18.1

Ruijie(config-route-map)# set ip next-hop 200.24.19.1

Ruijie(config-route-map)#!

Ruijie(config-route-map)#route-map PBR permit 20

Ruijie(config-route-map)# match ip address network_2

Ruijie(config-route-map)# set ip next-hop 200.24.19.1

Ruijie(config-route-map)# set ip next-hop 200.24.18.1

Ruijie(config)#ip policy redundance //Change the mode to redundancy backup mode.

Ruijie(config)#int g0/3

Ruijie(config-if-GigabitEthernet 0/3)#ip policy route-map PBR //Interface calling

DLDP part:

Ruijie(config)#int g0/1

Ruijie(config-if-GigabitEthernet 0/1)#dldp 200.24.18.1

Ruijie(config)#int g0/2

Ruijie(config-if-GigabitEthernet 0/1)#dldp 200.24.19.1

Welcome to Ruijie Community (https://community.ruijienetworks.com/)