Ruijie Community

Title: How to enable Layer 2 isolation in wireless user VLAN on AP? [Print this page]

Author: GTAC-Sophia Time: 2023-5-24 20:32
Title: How to enable Layer 2 isolation in wireless user VLAN on AP?
You can enable Layer 2 isolation for wireless user VLAN on AP with the following command:
Fit AP(Enter the following command on AC):

AC (config) #wids

-----> enter wids configuration mode

AC (config-wids) #user-isolation ssidd-ap enable

----- > Configure WLAN-based user isolation under AP

AC (config-wids) #user-isolation ap enable

-----> configure user isolation under AP

AC (config-wids) #user-isolation ssidd-ac enable

-----> configure WLAN-based user isolation under AC

AC (config-wids) #user-isolation ac enable

-----> configure user isolation under AC

AC (config-wids) #end

AC#write

Fat/MACC AP:

Ruijie #configure terminal

Ruijie (config) #wids

-----> enter wids configuration mode

Ruijie (config-wids) #user-isolation ssid-ap enable

-----> configure WLAN-based user isolation under AP

Ruijie (config-wids) #user-isolation ap enable

-----> configure user isolation under AP

Ruijie (config-wids) #end

Ruijie #write

Welcome to Ruijie Community (https://community.ruijienetworks.com/)