Title: How to enable Layer 2 isolation in wireless user VLAN on AP? [Print this page] Author: GTAC-Sophia Time: 2023-6-27 20:42 Title: How to enable Layer 2 isolation in wireless user VLAN on AP? You can enable Layer 2 isolation for wireless user VLAN on AP with the followingcommand:
Fit AP(Enter the following command on AC):
AC (config) #wids -----> enter widsconfiguration mode
AC (config-wids) #user-isolation ssidd-apenable----- > Configure WLAN-based user isolation under AP
AC (config-wids) #user-isolation ap enable-----> configure user isolation under AP
AC (config-wids) #user-isolation ssidd-ac enable-----> configure WLAN-based user isolation under AC
AC (config-wids) #user-isolation ac enable-----> configure user isolation under AC
AC (config-wids) #end
AC#write
Fat/MACC AP:
Ruijie #configure terminal
Ruijie (config) #wids -----> enter widsconfiguration mode
Ruijie (config-wids) #user-isolation ssid-ap enable-----> configure WLAN-based user isolation under AP
Ruijie (config-wids) #user-isolation ap enable-----> configure user isolation under AP
Ruijie (config-wids) #end
Ruijie #write
Welcome to Ruijie Community (https://community.ruijienetworks.com/)