Title: How to configure LAN port settings on wireless bridge? [Print this page] Author: GTAC-Sophia Time: 2023-7-4 16:14 Title: How to configure LAN port settings on wireless bridge? The address of a LAN port is used only for login to the web page and does not affect the service network.
1. Allocating IP Addresses to All Bridges in the Network
When a large number of devices in the network require IP addresses, you can Choose: Overview>Other Network Config >IP Allocation to automatically allocate IP addresses for each device.
When a large number of devices in the network require static IP addresses, you can configure static IP addresses for each device. Click IP Allocation, set Internet to Static IP Address, set Start IP Address, Subnet Mask, Gateway, and DNS Server, and click OK.
When a large number of devices in the network require dynamic IP addresses, you can configure dynamic IP addresses (DHCP) for the entire network so that each device can dynamically obtain an IP address. Set Internet to DHCP and click OK.
2. Setting the IP address of a LAN Port on the Local Device
Open the LAN page. If a DHCP server is deployed in the network, you are advised to set Internet to DHCP. If no DHCP server is deployed, set Internet to Static IP Address, set IP Address, Subnet Mask, Gateway, and DNS Server, and click Save.
Note: After the configuration, the device IP address changes, and the device web page cannot be accessed. You need to enter the new IP address in the browser address bar and ensure that the IP addresses of the management computer and the device are in the same network segment. If they are not in the same network segment, reconfigure the IP address of the management computer. Therefore, exercise caution when performing this operation.
Welcome to Ruijie Community (https://community.ruijienetworks.com/)
