Title: How do I use the WPS button on my Reyee router? [Print this page] Author: GTAC-Sophia Time: 2023-7-25 11:37 Title: How do I use the WPS button on my Reyee router? RG-EW1200R and RG-EW300R are Wi-Fi extenders that support working in WPS (Wi-Fi Protected Setup) mode.
WPS mode can be set up as follows:
1. Press the WPS button on the primary router.
2. Click the WPS button on the Wi-Fi extender after you click the WPS button on the main router within two minutes.
3. The three-bar signal indicators will blink alternately, and then remain lit up steadily, which implies the WPS connection is done.
Note:
1. RG-EW1200Rsupports Reyee Mesh while RG-EW300R does not support Reyee Mesh.
2. When your main router is Reyee Mesh Wi-Fi Series, you can mesh EW1200R with the main router.
When your main router is a device supporting the WPS function, you can choose WPS mode.
Otherwise, you can choose Repeater mode.
3. The device already in the WPS networking status will not be paired again if you press the WPS button. Author: reillymueller16 Time: 2024-1-12 10:56
Thanks for the clear WPS setup guide! I have an RG-EW1200R extender and was struggling to connect it to my main router. This walkthrough was easy to follow, and the screenshots definitely helped.
Welcome to Ruijie Community (https://community.ruijienetworks.com/)