Ruijie Community

Title: How to connect RG-EW Wi-Fi extenders to the primary router using the WPS button? [Print this page]

Author: linyonghang1@ru    Time: 2023-8-4 10:20
Title: How to connect RG-EW Wi-Fi extenders to the primary router using the WPS button?
RG-EW1200R and RG-EW300R are Wi-Fi extenders that support working in WPS (Wi-Fi Protected Setup) mode.

WPS mode can be set up as follows:
1. Press the WPS button on the primary router.
2. Click the WPS button on the Wi-Fi extender after you click the WPS button on the main router within two minutes.
3. The three-bar signal indicators will blink alternately, and then remain lit up steadily, which implies the WPS connection is done.

Note:
1.      RG-EW1200Rsupports Reyee Mesh while RG-EW300R does not support Reyee Mesh.
2.      When your main router is Reyee Mesh Wi-Fi Series, you can mesh EW1200R with the main router;
            When your main router is a device supporting the WPS function, you can choose WPS mode;
            Otherwise, you can choose Repeater mode.
3. The device already in the WPS networking status will not be paired again if you press the WPS button.





Welcome to Ruijie Community (https://community.ruijienetworks.com/) Powered by Discuz! X3.2