Ruijie Community

Title: Error code analysis for User Offline in Second Generation Web Authentication Mode [Print this page]

Author: admin Time: 2018-4-10 08:32
Title: Error code analysis for User Offline in Second Generation Web Authentication Mode
Error code analysis for User Offline in Second Generation Web Authentication Mode

Author: admin Time: 2018-4-10 08:33

01: The user actively goes offline.

02: The port is disconnected. On a wirelessnetwork, STAMG notifies STA to go offline. In this case, contact STAMG owner tolocate the cause.

03: The service is unavailable mainly due toconnection interruption.

04: Idle status times out. The user having notraffic is kicked out.

05: Session times out. The duration reaches.

06: The administrator resetsthe port or session to kick out users from the RADIUS server, kick out escapedusers after restoring the Portal server, or run the clear command to deleteusers.

07: The administrator restarts NAS.

08: The port has an error and required tointerrupt the session

09: NAS has an error and required interruptingthe session.

10: NAS requires interrupting the session dueto other reasons.

11: NAS is restarted accidentally.

12: NAS thinks there is no need to retain theport and interrupts the session.

13: NAS interrupts the session to allocatethis port.

14: NAS interrupts the session to suspend theport.

15: NAS fails to provide the requiredservice.

16: NAS interrupts the currentsession to call back the new session.

17: Information entered by the user isincorrect.

18: The host requires interrupting thesession.

103: The IP or MAC address has changed oroccupied.

115: The service is switched over.

122: The traffic is exhausted.

250: The low-traffic user is kicked out. Itis a unique attribute of Ruijie AP and the cause is same to code 4.

500: Authentication times out. The RADIUSauthentication packet is not responded within the time limit. This attribute isavailable for wireless wlog module and will be provided for SNC later.

501: Authentication is denied by the RADIUSserver. This attribute is available for wireless wlog module and will beprovided for SNC later.

502: The number of users on the device hasreached the upper limit. This attribute is available for wireless wlog moduleand will be provided for SNC later.

Welcome to Ruijie Community (https://community.ruijienetworks.com/)