Title: How to fix when modification to the non-root AP do not take effect on the AC? [Print this page] Author: admin Time: 2018-4-11 22:33 Title: How to fix when modification to the non-root AP do not take effect on the AC?
How to fix when modification to the non-root AP do not take effect on the AC?
Author: admin Time: 2018-4-11 22:34
All the commands for modifying the non-rootbridge configuration take effect only after the wds config commit command is run.
In ap-configmode, run the wds config [ clear |commit ] radio radio-id command. The parameters are described below:
clear: Clears WDS configuration that does nottake effect. commit: Commits WDS configuration that doesnot take effect. After the operation, the bridge is disconnected and thenconnected. radio radio-id: Indicates the radio IDconfigured on the AC.
If the AP is in non-root mode, its radioenters the wds edit mode. At this time, most of wds commands do not take effectimmediately. You can run the show ap-config wds-config command to display theconfigurations. After confirming that the configurations are correct, run thiscommand to commit the modification.
Welcome to Ruijie Community (https://community.ruijienetworks.com/)