Ruijie Community

Title: How to specify the IP address of the Capwap tunnel by command on WS6008? [Print this page]

Author: linyonghang1@ru    Time: 2023-8-11 10:06
Title: How to specify the IP address of the Capwap tunnel by command on WS6008?
By default, the capwap tunnel address of the wireless controller is the interface address of loopback 0. You can also modify it with the following command

Ruijie(config)#ac-controller

Ruijie(config-ac)#capwap ctrl-ip  xx.xx.xx.xx--------Configure the specified tunnel address

Ruijie(config-ac)#end

Ruijie#wr






Welcome to Ruijie Community (https://community.ruijienetworks.com/) Powered by Discuz! X3.2