Title: How to change the port rate from 25G to 10G via CLI commands on RG-S6510-48VS8CQ? [Print this page] Author: linyonghang1@ru Time: 2023-8-14 11:18 Title: How to change the port rate from 25G to 10G via CLI commands on RG-S6510-48VS8CQ? You can use these CLI commands on RG-S6510-48VS8CQ to change the port rate from 25G to 10G:
Ruijie>enable
Ruijie#config
Ruijie(config)#int TFGigabitEthernet 0/32
Ruijie(config-if-TFGigabitEthernet 0/32)#port speed-mode 10G //change the port speed mode
Warning: Ports TF0/29 - TF0/32 will be set speed mode 10G. Continue? [Y/N]:y
Ruijie(config-if-TFGigabitEthernet 0/32)#end
Ruijie#write
Welcome to Ruijie Community (https://community.ruijienetworks.com/)