Ruijie Community

Title: What is the CLI command to configure LACP on Ruijie Switch? [Print this page]

Author: linyonghang1@ru Time: 2023-8-18 14:57
Title: What is the CLI command to configure LACP on Ruijie Switch?
You can use these CLI commands to configure static link aggregation on Ruijie Switch:

Ruijie>enable

Ruijie#config

Ruijie(config)#interface range gigabitEthernet 0/1-3

Ruijie(config-if-range)#port-group 1 mode active

Ruijie(config-if-range)#exit

Ruijie(config)#interface aggregateport 1

Ruijie(config-if-AggregatePort 1)#switchport mode trunk

Ruijie(config-if-AggregatePort 1)#end

Ruijie#wr

Welcome to Ruijie Community (https://community.ruijienetworks.com/)