Ruijie Community

Title: How to setup EG105G-V2 Load Balancer as a FAILBACK to Active. [Print this page]

Author: gonato.mikhael@ Time: 2023-9-23 15:36
Title: How to setup EG105G-V2 Load Balancer as a FAILBACK to Active.
How would I choose to do a failback? I have to ISP's, on WAN0 and WAN1. I tested the FAILOVER and it works, however the FAILBACK did not. When WAN0 has recovered it stayed in WAN1.

Can someone explain how would I go about choosing a Load Balancing Policy?

Also, can you explain the differences between these 4

TIA

Author: GTAC-Jayden Time: 2023-9-23 15:43
Dear User 48367,

Please refer to page 50 of https://www.ruijienetworks.com/resources/preview/ruijie-reyee-rg-eg-series-routers-web-based-configuration-guide-release-reyeeos-2-237 for the difference between different load balancing policy:

Best regards,
Jayden

Author: gonato.mikhael@ Time: 2023-9-23 18:28

GTAC-Jayden replied at 2023-9-23 15:43
Dear User 48367,

Please refer to page 50 of https://www.ruijienetworks.com/resources/preview/ruijie ...

The help option found on the eWeb is THE SAME on the page 50 and this document and neither explains how I would go about a failback option nor a documented explanation if Active/Secondary has one. That option/feature should have been OOTB.

Author: GTAC-Jayden Time: 2023-9-23 19:15

User 48367 replied at 2023-9-23 18:28
The help option found on the eWeb is THE SAME on the page 50 and this document and neither explain ...

Dear User 48367,

If you configure the Active/Secondary mode, all the traffic will go through the primary interface and only switches to secondary interface when the primary interface is detected as offline. When the primary interface is online again, the traffic will be restored to primary interface, may I please know how you tested the failback? You may use traceroute function to check which route the traffic is going through.

Best regards,
Jayden

Author: gonato.mikhael@ Time: 2023-9-24 09:36

GTAC-Jayden replied at 2023-9-23 19:15
User 48367 replied at 2023-9-23 18:28
The help option found on the eWeb is THE SAME on the page 50 a ...

Dear Jayden,

I manually plugged out the primary, rolling off to the secondary ISP after a few seconds. I plugged in to the Primary and waited to Failback which it didn't happen. Upon checking my public IP and tracerouting it still the same. WAN0 has low ping in some games, WAN1 has very high ping in some games. This is why I'm concerned about the failback

Author: GTAC-Jayden Time: 2023-9-26 13:05

User 48367 replied at 2023-9-24 09:36
Dear Jayden,

I manually plugged out the primary, rolling off to the secondary ISP after a few sec ...

Dear User 48367

In order to troubleshoot this issue more efficiently, could you please enter RITA live chat (www.ruijienetworks.com/rita) when you are available? Please provide the case ID CS20230926-2477790 to the online agent to save you time describing the same issue again.

Best regards,
Jayden

Welcome to Ruijie Community (https://community.ruijienetworks.com/)